Archive for month: December, 2020

This is how I configured IPv6 address received dynamically from my ISP. This is not to be confused with using a 6to4 tunnel service which is something completely different. In this case, a real IPv6 address is received using DHCP6 or SLAAC from the ISP.

In this setup the IPv6 LAN side is bridged with the IPv6 WAN side, so the LAN subnet is a part of the larger WAN subnet. Firewall rules will apply even though it is a bridged, not routed setup.

1. Go to WAN -> WAN settings -> IPv6 Settings and select DHCP, check DHCP-PD and enter “0” for Prefix name. Apply.
   
2. Go to Status and Statistics -> IPv6 tab and verify that you get a IPv6 address from your provider (starting with 2a02 in my case).
   
3. Go to LAN -> VLAN Settings and select vlan 1, click edit button.
   
   In the IPv6 sections, select prefix from WAN 0, in my case address beginning with 2a02 and /48 size.
   Enter 0 for suffix, 64 for prefix length, leave DHCP Type disabled. Apply.
4. Go to LAN -> Router advertisment and click Enable, select Unicast, do not select Managed or Other. Make sure the IPv6 prefix is visible in the Prefix table.

Done.