Improving wifi in a crowded wifi environment

This is a litle trick I use when I travel and hook up to a wifi network in a crowded wifi environment. Sometimes the network performance over wifi is really bad and the problem is that it can be caused by heavy traffic (like file sharing) on another wifi network sharing the same channel as yours. I have experienced this especially when travelling to big cities like Paris, Amsterdam and so on. First of all, it is recommended that you disable 802.11n wifi mode which works terribly bad in crowded environments. See this article for Windows and this for Linux (Ubuntu).

Crowded wifi environment (Wifi Analyzer for Android)

The problem with the wifi technology is that networks in the neighbourhood is sharing the same channels. In the 2,4 GHz band there are only 11-14 channels availible (depending on your region) and those channels overlap. That means if your network is on channel 1 you will get interference with traffic on channels 1, 2 and 3. Another problem with wifi is that is has no means of evenly dividing the capacity (like timeslots), so it is kind “the one shouting highest gets the most bandwidth”. And when someone already is using a lot of bandwidth (like file sharing) it is very hard for other users to obtain a part of the bandwidth. Even if it is the neighbours wifi which you can’t access but it shares the wifi channel.

A countermeasure to improve the situation is to constantly use some bandwidth forcing the heavy users to pull back a bit. Before transmitting, each node in the network listens in the air if the channel is free, so by using a little bit of bandwidth even if idle you don’t give the other node the same possibilty to hog the entire capacity.

First of all, find out the IP address of your local network default gateway. In WIndows you run a command prompt (cmd) and type the command ipconfig. In Linux you can use netstat -rn.

To constantly use up a small portion of the bandwidth I use the ping comand. Ping normally sends very small packets (56 bytes), but to get this to work we need a bit larger packets (but not to large, then we will hog the entire capacity). 1024 bytes is good.

In Windows you run the command (replace 192.168.0.1 with the IP-address of your local network which you found out above):

ping -t -l 1024 192.168.0.1

and in Linux you run:

ping -s 1024 192.168.0.1

ping with 1024 bytes

Voila! Now my wifi connection gets a lot more stable because I force the other wifi nodes to pull pack a bit since I constantly make them aware of my presence.