When the cover is removed use a 10 mm wrench to adjust the brake to the desired tensions. Install the cover in the reverse order as described above.
Stefan Helander

VW e-up parking break adjustment

/0 Comments/in /by

Adjusting the parking break on VW e-up is quite easy. It requires a couple of screwdrivers and a 10 mm wrench.

In the bottom of the rear cup holder, use a little flat screwdriver to remove the screw cover.

Find the screw covered by a cup in the bottom of the rear cup holder.
Find the screw covered by a cup in the bottom of the rear cup holder.
Use a small flat screw driver to remove the cap.
Use a small flat screw driver to remove the screw cover.
Remove the torx screw, lift the console a little and push it forward to remove it.
Remove the torx screw, lift the console a little and push it forward to remove it.
When the cover is removed use a 10 mm wrench to adjust the brake to the desired tensions. Install the cover in the reverse order as described above.
Use a 10 mm wrench to adjust the parking break to the desired tension. Reassemble everyting in reverse order.